CCNP R&S Question of the Week: Interface FastEthernet0/1

Interface FastEthernet0/1 is configured as a trunk that permits all VLANs. The following command is configured:  monitor session 2 filter vlan 1 – 8, 39, 52

What is the result of the implemented command?

A. All VLAN traffic is sent to the SPAN destination interface.
B. Traffic from all VLANs, except 1 to 8, 39 and 52 are sent to the SPAN destination interface.
C. Filtering a trunked SPAN port is not supported.
D. The trunk’s native VLAN must be changed from its default VLAN 1.
E. Traffic from VLANs 1 to 8, 39, and 52 are sent to the SPAN destination port.

Reveal Answer

Answer: E.

The “monitor session filter” command is used to specify which VLANS are to be port mirrored using SPAN feature.

 

Related Courses
ROUTE – Implementing Cisco IP Routing v2.0
SWITCH – Implementing Cisco IP Switched Networks v2.0
TSHOOT – Troubleshooting and Maintaining Cisco IP Networks v2.0

Related Certification
CCNP Routing and Switching

CCNP R&S Question of the Week Series

• CCNP R&S Question of the Week: IPv6
• CCNP R&S Question of the Week: BGP Attribute
• CCNP R&S Question of the Week: Gateway of Last Resort
• CCNP R&S Question of the Week: Routing Protocols into OSPF
• CCNP R&S Question of the Week: BPDU Guard
• CCNP R&S Question of the Week: Private VLANs
• CCNP R&S Question of the Week: Blocking to Forwarding State
• CCNP R&S Question of the Week: FTP to HTTP
• CCNP R&S Question of the Week: Alerts
• CCNP R&S Question of the Week: Configuration Sequence
• CCNP R&S Question of the Week: TCP Traffic
• CCNP R&S Question of the Week: IPv4 and IPv6
• CCNP R&S Question of the Week: clear ip route
• CCNP R&S Question of the Week: IPv6 Traffic Filter Impact
• CCNP R&S Question of the Week: EtherChannel
• CCNP R&S Question of the Week: Interface FastEthernet0/1

from
CERTIVIEW